DIY Motorola Moto One 5G ACE Front | Rear Camera Repair Guide

Before Starting, we need to have the right tools to proceed with the repair, which You can find in the description.

First, turn off the phone, take out the sim tray, and follows with the back cover removal.

To remove the back cover, it needs to heat gently around the back cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes. Alternatively, you can use a heat gun or hairdryer.

Next, create an opening using a suction cup and then insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Next, using a heat gun, apply heat to soften the glue on the fingerprint button.

Next, Hold the touch id button and pull out the back cover from the body.

Next, Take out the board frame by undoing ten screws. Be gentle with the fingerprint button.

Next, disconnect the battery plug by raising the graphite tape.

Next, pull out the not working front camera from the board.

Next, pull out the not working macro camera from the board.

Next, pull out the logic board to disconnect wide and ultrawide cameras from the board.

Next, disconnect two antenna heads, main ribbon connector and lcd connector from the board. And then take out the sim tray and undo two screws from the logic board.

Next, gently lift the board using a pry tool.

Next, pull out the broken wide and ultrawide cameras from the board.

Next, place new wide and ultrawide cameras on the board. If your replacement part is coming without the copper tape, please remove it from the old unit and put it on the new cameras.

Next, gently secure the board to the logic board.

Next, secure two screws and insert the sim tray and then connect two antenna heads and two plugs to the board.

Next, place the new macro camera into the board.

Next, place the new front camera with copper tape.

Next, connect the battery plug.

Next, place the board frame by adding ten screws. Ensure the fingerprint button has secured on the frame.

Next, Before installing the main back cover, make sure it has enough glue. If not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body. If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the replacement guide.Let us know if you have any questions.