DIY Motorola Moto G Fast XT2045 LCD Touch Screen Repair Guide

Before Starting, we need the right tools to proceed with the repair, which You can find in the description.

First, Take out the back cover from the body. To remove the back cover, it needs to heat gently around the rear cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes.

Alternatively, you can use a heat gun or hairdryer. Next, create an opening using a suction cup and then insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Next, gently take out the back cover by holding the fingerprint button.

Next, pull out the logic board frame with the lens by undoing ten screws.

Next, Disconnect the battery plug by moving the fingerprint button.

Next, pull out the not battery from the body.

First, apply heat to soften the glue under the battery.

You can use a heat pad, heat gun, or hair dryer.

And then, use a pry or card pry tool to cut the adhesive under the battery.

This process will take time.

Next, gently pull out the battery from the body.

Next, Disconnect the Main Flex and LCD Connector plugs from the board.

Next, release the adhesive from the front camera.

Next, disconnect two antenna heads from the logic board.

Next, Eject the sim tray.

Next, gently pull out the logic board from the body.

Next, pull out the earpiece module from the frame.

Next, take out the speaker cover by undoing eight screws.

Next, Gently pry the main flex cable from the body.

Next, release both antenna from the frame.

Next, undo the screw holding the board.

Next, disconnect and pull out the main flex from the charging port board.

Next, pull out the charging port board with antennas from the frame.

Next, apply some heat to release the vibrator motor from the frame.

The only remaining part is the broken front screen assembly with the frame.

For the replacement, there are two different screen types in the market.

One is with the frame, and the other is without the frame.

It can be original, used, refurbished, or aftermarket.

Either version you choose, you can get with the frame and without.

But the most straightforward repair will be with the frame, and the price difference is slight.

I recommend you go with a screen with the frame installed.

It can be original, refurbished, used, or aftermarket. And this type is commonly available to purchase.

Next, on the new screen frame, start placing the removed parts.

First, place and secure the logic board on the new screen frame.

Next, insert the sim tray.

Next, connect the lcd plug.

Next, secure the earpiece module.

Next, place secure the vibrator motor.

Next, place and secure the charging port board with antennas on the frame.

Next, secure both antennas in the frame slot.

Next, secure the main flex from both sides.

Next, secure the speaker cover by adding eight screws.

Next, connect both antennas to the logic board.

Next, secure the battery with adhesive.

Next, connect the battery plug.

Next, secure the board frame by adding ten screws.

Next, place the fingerprint button.

Next, Before installing the main back cover, ensure it has enough glue.

If not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body.

If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the replacement guide. Let us know if you have any questions.