DIY Motorola Moto G Power 2021 Charging Port Repair Guide

Before Starting, we need the right tools to proceed with the repair, which You can find in the description.

First, Take out the back cover from the body. To remove the back cover, it needs to heat gently around the rear cover edges until the pasted adhesive becomes soft. For this, we are using a heating pad.

Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes.

Alternatively, you can use a heat gun or hairdryer.

Next, create an opening using a suction cup and then insert a plastic card pry tool o something similar to cut the adhesive around the back cover.

Next, gently take out the back cover.

Next, pull out the logic board frame with the lens by undoing eleven screws.

Next, Disconnect the battery plug.

Next, take out the speaker cover by undoing eight screws.

Next, disconnect the main flex and disconnect and relax two antenna heads.

Next, remove the not working charging port board by undoing the screw.

Next, place and secure the new charging port board.

Next, secure the screw and connect the main flex and then secure both antenna heads to the board.

Next, place and secure the speaker cover by adding eight screws.

Next, connect the battery plug and secure the board frame by adding eleven screws.

Next, Before installing the main back cover, ensure it has enough glue.

If not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body.

If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the camera Lens replacement guide. Let us know if you have any questions.