DIY Motorola Moto G Stylus 5G XT2131 LCD Touch Screen Repair Guide

Before Starting, we need the right tools to proceed with the repair, which You can find in the description.

First, Take out the back cover from the body.

To remove the back cover, it needs to heat gently around the rear cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes.

Alternatively, you can use a heat gun or hairdryer.

Next, create an opening using a suction cup and then insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Next, gently take out the back cover by holding the fingerprint button.

Next, pull out the logic board frame with the lens by undoing eight screws.

Next, Disconnect the battery plug by moving the fingerprint button.

Next, release the adhesive on the bottom of the battery.

Next, fold the graphite tape and secure it.

Next, pull out the battery from the body.

First, apply heat to soften the glue under the battery.

And then, use a pry or card pry tool to cut the adhesive under the battery.

Next, gently pull out the battery from the body.

Next, disconnect two antenna heads from the logic board.

Next, move the graphite tape and disconnect two connector plugs.

Next, take out the sim tray.

Next, undo the battery holding the logic board.

Next, gently take out the logic board from the body.

Next, take out the earpiece module.

Next, take out the speaker cover by undoing seven screws.

Next, undo the screw on the charging port
board.

Next, gently pry the main flex cable and antennas
from the body.

Next, pull out the logic board from the body.

Next, take out the vibrator motor from the body.

If needed add some heat to soften the adhesive on the motor flex.

Now the only remaining part is the broken screen assembly with the frame.

For the replacement, there are two different screen types in the market.

One is with the frame, and the other is without the frame.

It can be original, used, refurbished, or aftermarket.

Either version you choose, you can get with the frame and without.

But the most straightforward repair will be with the frame, and the price difference is slight.

I recommend you go with a screen with the frame installed.

It can be original, refurbished, used, or aftermarket.

And this type is commonly available to purchase.

Next, on the new screen frame, start placing the removed parts.

First, secure the earpiece module.

Next, gently place and secure the logic board to the frame.

Secure the board by adding the screw, connect the LCD plug, and insert the sim tray.

Next, secure the vibrator motor.

Next, secure the charging port board and place both antennas on the frame, and
then connect both to the logic board.

Next, secure the main flex by connecting from both ends.

Next, secure the battery by adding adhesive.

Next, secure the speaker cover by adding seven screws.

Next, place the graphite tape.

Next, secure the tape on the bottom.

Next, connect the battery plug and place the fingerprint button.

Next, secure the board frame by adding eight screws.

Next, Before installing the main back cover, ensure it has enough glue.

If not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body.

If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the replacement guide. Let us know if you have any questions.