DIY Samsung Galaxy S10 5G Camera Repair Guide

To start, we need to have the right tools to proceed with the repair, which You can find in the description.

First, Take out the SIM tray and then the back cover removal.

To remove the back cover, it needs to heat gently around the back cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad Select the mobile phone HEATING option and leave it till it completes. Alternatively, you can use a heat gun or hairdryer.

Once the heating has been completed, Use a suction cup to create an opening between the frame and the rear cover. Next, insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Next, take out the back cover. Next, undo five screws and disconnect the connector to take out the wireless pad. Also disconnect the battery plug.

Next, take out the board bracket by undoing four screws.

Next, take out the not-working front camera by disconnecting two plugs.

Next, to take out the broken front camera, first, take out the logic board by disconnecting four plugs.

Take out the logic board and disconnect three camera connectors from the rear side of the board.

Next, Apply a little heat to soften the glue under the camera unit, and then gently take out the broken rear camera unit using a pry tool.

Next, place the new rear camera unit by securing three plugs.

Next, place the logic board in the body.

Next, secure four connector plugs to the board.

Next, place the new front camera on the board by securing two plugs.

Next, place the board bracket with four screws.

Next, secure the battery plug.

Next, add the sim tray and place the wireless pad by securing five screws and the connector. Also, connect the battery plug

Next, Before installing the main back cover, make sure it has enough glue on it. If not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are using screen binding clips to tighten the back cover to the body. If not, you can use rubber bands and leave them for some time.

I hope you have enjoyed the replacement guide.

Let us know if you have any questions