Samsung Galaxy A15 5G Camera Replacement Guide

Today, we’ll walk you through how to replace the front and rear camera modules on the Samsung Galaxy A15 5G. Follow the steps carefully to fix your broken or not-working , and make sure you have the proper tools listed in the description.

---

Compatibility and Model Numbers

This repair guide based on Samsung Galaxy A15 5G device, but it also compatible with Galaxy A15 4g and Galaxy M15 models.

Compatible Mode Numbersl SM-A156B, SM-A156B/DS, SM-A156P, SM-A156P/DS, SM-A156U, SM-A156U1, SM-A156U1/DS, SM-A156W, SM-A156P/N, SM-A156P/DSN, SM-S156VL, SM-A156M, SM-A156E, SM-A156E/DSN SM-A155F, SM-A155F/DSN, SM-A155M, SM-A155M/DS, SM-A155P, SM-A155R SM-M156B, SM-M156B/DS, SM-M156B/DSN

---

Tools to open Galaxy A15 Series

• Mobile phone heating pad or hairdryer/heat gun
• Plastic pry tool / card pry
• Suction cups
• Phillips #00 screwdriver
• Tweezers (for connectors)
• B7000 glue or double-sided adhesive (for back cover)
• Rubber bands or bonding clips to secure the back cover

👉 How to Use Tools for the Repair

How to Find Tools and Parts

• Heating pad – https://amzn.to/3H0tHzJ
• Portable Heat Gun – https://amzn.to/4mszih1
• Clamps https://amzn.to/3GYJT4w
• STREBITO 142 Piece Repair Tool Kit https://amzn.to/3UO1jUx
• Glue | Adhesive https://amzn.to/46exVxe
• Compatible Parts https://amzn.to/4pOwJIM
• Silicone Work Repair Mat https://amzn.to/45Emz5l

---

Step 1 – Power Off & Prepare the Device

Turn off the phone completely, remove the SIM tray, and get ready to open the back cover.

---

Step 2 – Remove the Back Cover

To access the cameras, the back cover must be removed.

Gently heat the edges to soften the adhesive.

We’re using a heating pad—place the back cover side down, select the Mobile Phone Heating option, and allow it to complete the full cycle.

You can also use a heat gun or hairdryer.
Be careful not to overheat, as this can damage internal components or warp the back cover.

Use a suction cup at the bottom edge to create a small gap, then insert a plastic pry card. Slide the card around the edges to slowly cut the adhesive.
Take your time and stay gentle—avoid damaging any flex cables inside.

Once fully loosened, lift and remove the back cover.

Change Cracked Back Cover & Camera Lens in This Step

---

Step 3 – Remove Mid-Frame

Ensure the SIM tray is removed.

Undo all 15 screws securing the mid-frame.

Disconnect the fingerprint/power button flex cable.

Use a pry card to separate the mid-frame from the body. Work around all edges to release the plastic clips.
This process takes time—do not force it.

Once released, lift away the mid-frame.

Disconnect the battery connector.

---

Step 4 – Remove Faulty Camera Modules

Now you can remove each camera one by one.

Front Camera

Disconnect and lift the faulty front camera from its slot.

Macro Camera

Disconnect and remove the non-working macro camera.

Main Camera

Disconnect and free the faulty main rear camera.

Ultra-Wide Camera

This camera sits under the logic board.

Undo the single screw holding the board.
Gently lift or flip the board to access the ultrawide camera connector.

Disconnect and remove the faulty ultrawide camera.

---

Step 5 – Install the New Cameras

Now place the new cameras back in their correct positions.

1. Install the new ultrawide camera, then secure the logic board with its screw.
2. Install the new main camera.
3. Install the new macro camera.
4. Install the new front camera.

Make sure each connector clicks firmly into place.

---

Step 6 – Reassemble the Phone

Reconnect the battery.

Place the mid-frame back and secure all 15 screws.
Make sure all clips are properly aligned before tightening.

Reconnect the fingerprint button flex cable.

Insert the SIM tray.

Before placing the back cover, check if it still has good adhesive.
If not, apply B7000 glue or use a new double-sided adhesive.

Secure the rear cover using bonding clips.
If you don’t have clips, rubber bands can apply even pressure.
Leave them on for some time to ensure strong bonding.

---

Hope you enjoyed this repair guide!

If you have any questions, drop them in the comments.
Please like, share, and subscribe for more repair guides.

Checkout Other Repair Guides

 Frequently Asked Questions

1. How Many Cameras in A15 5G phone?

it has Three rear cameras, a main camera, a macro camera, and an ultra-wide camera, also it comes with one front facing camera.

2. Do I need to remove the logic board to replace the ultrawide camera?

Yes, the ultrawide camera sits under the board, so you must lift or flip the board after removing its screw.

4. How long does the camera replacement take?

Beginners: 25–40 minutes
Experienced technicians: 10–15 minutes

5. Do I need new adhesive for the back cover?

If the existing glue is weak, use B7000 or new double-sided adhesive for a proper seal.