DIY Google Pixel 4xl Charging Port Repair Guide

To start, we need to have the right tools to proceed with the repair, which You can find in the description.

First, turn off the phone and follow the back cover removal.

For this, we are using a heating pad. Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes. Alternatively, you can use a heat gun or hairdryer.

Once the heating has completed, Use a suction cup to create an opening between the frame and rear cover. Next, insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

While removing the back cover, be gentle. The flash sensor plug connects with the back cover.

Next, take out the bracket by undoing four screws to undo the battery plug.

Next, take out the sensor bracket by undoing two screws. Please note one screw is missing on our device. And then disconnect the plug to release the back cover from the body.

Next, take out the battery from the body.

First, apply heat to soften the glue on the battery. For this, we are using a heat gun. Once you feel the heating is enough, use a pry tool to cut the adhesive under the battery.

Next, take out the bracket by undoing four screws.

Next, Take out the speaker module by undoing three screws.

Next, disconnect the antenna head and move the cable aside.

Next, take out the not working charging port flex by disconnecting the taptic engine & antenna plugs. Be gentle in this process and pry the cable to take out.

Next, place the new charging port flex on the body and then secure the connector.

Next, secure the taptic engine, antenna board plugs and antenna head to the port.

Next, Place the speaker by adding three screws.

Next, place the bracket by adding four screws.

Next, place the battery with adhesive.

Next, connect the back cover sensor flex to the board and place the bracket by adding two screws. Once again, our device has one screw, but yours should have two.

Next, secure the battery plug and place the bracket by adding four screws.

Next, Before installing the main back cover, make sure it has enough glue; if not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body. If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the replacement guide. Let us know if you have any questions.