DIY Motorola Moto G Stylus 2021 Charging Port & Headphone Jack Board Repair Guide

Before Starting, we need the right tools to proceed with the repair, which You can find in the description.

First, Take out the back cover from the body.

To remove the back cover, it needs to heat gently around the rear cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad.

Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes.

Alternatively, you can use a heat gun or hairdryer.

Next, create an opening using a suction cup and then insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Next, remove the back cover and undo eleven screws to take out the logic board frame.

Next, disconnect the battery connector.

Next, take out the speaker cover by undoing seven screws.

Next, unplug two antenna heads and the main ribbon connector cable from the charging port board.

Next, undo the screw on the charging port board.

Next, pull out the not working charging port board from the body.

Next, place and secure the new charging port board with the headphone jack to the body.

Next, secure the board by adding the screw.

Next, secure both antenna heads and the main flex to the board.

Next, secure the cover by adding seven screws.

Next, connect the battery plug and secure bthe board frame by adding eleven screws.

Next, Before installing the main back cover, ensure it has enough glue.

If not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body.

If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the camera Lens replacement guide. Let us know if you have any questions.