DIY Motorola Moto G8 Power 2020 Charging & Headphone Jack Port Repair Guide

Before Starting, we need to have the right tools to proceed with the repair, which You can find in the description.

First, turn off the phone, take out the sim tray, and follows with the back cover removal.

To remove the back cover, it needs to heat gently around the back cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes. Alternatively, you can use a heat gun or hairdryer.

Next, create an opening using a suction cup and then insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Next, using a heat gun, apply heat to soften the glue on the fingerprint button.

Next, Hold the touch id button and pull out the back cover from the body.

Next, Take out the board frame by undoing Nine screws. Be gentle with the fingerprint button.

Next, disconnect the battery plug by releasing the graphite tape.

Next, release the black tape on the bottom of the battery.

Next, take out the speaker cover by undoing five screws and releasing the tape.

Next, disconnect two antenna heads from the charging board.

Next, using a pry tool, lift the charging board. Be gentle; the connector plug is on the rear side of the board.

Lift the board from the bottom and disconnect the connector to release the not working charging board.

Next, secure the connector plug and place the new charging port board on the body.

Next, secure two antenna heads to the board.

Next, place the cover by adding two screws. And also, secure the tape.

Next, secure the battery connector and place the tape.

Next, place the board frame by adding nine screws. Ensure the fingerprint button is secured.

Next, Before installing the main back cover, make sure it has enough glue. If not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body. If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the replacement guide.Let us know if you have any questions.