DIY OnePlus 9 Pro Camera Glass Lens Repair Guide

Before Starting, we need to have the right tools to proceed with the repair, which you can find in the description.

First, take out the SIM tray and then the back cover removal. To remove the back cover, it needs to heat gently around the back cover edges until the pasted adhesive becomes soft.

For this, we are using a heat gun to carefully work around the back cover edges and apply the heat to soften the glue on the back cover.

Alternatively, you can use a heat pad or hair dryer. Once the heating has been completed, use a suction cup to create an opening between the frame and the rear cover.

Next, insert a plastic card, pry tool, or something similar to cut the adhesive around the back cover.

Next, take out the back cover and remove the camera lens separately. Heat to soften the glue on the rear side of the camera lens.

Once you feel the heating is enough, first, if needed, you can take out the two main camera lens rings by applying slight pressure from the rear side.

If not, apply slight pressure from the rear side to create an opening and then use a car pry tool or something similar to cut the adhesive under the camera lens. Be gentle and take out the camera lens.

There are three different replacement parts available for this repair. You can select the cameras with the frame or the camera lens without the frame or just two camera lens rings.

Select the required part to replace the new camera lens and apply adhesive to it. Most of the time, the replacement camera lens comes with adhesive. Otherwise, you can use b7000 glue or double-sided adhesive.

Next, before installing the main back cover, make sure it has no glue on it. If not, use b7000 glue on your double-sided backup adhesive.

Finally, we add binding clips to tighten the rear car with the body. If not, you can use some rubber bands and leave them for some time.

Hope you have enjoyed the replacement guide, and let us know if you have any questions.