DIY Redmi Note 11 Pro | Xiaomi 11i Hypercharge 5G Teardown Repair Guide

Before Starting, we need to have the right tools to proceed with the teardown, which You can find in the description.

First, turn off the phone and follows with the back cover removal.

To remove the back cover, it needs to heat gently around the rear cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes. Alternatively, you can use a heat gun or hairdryer.

Once the heating has completed, Use a suction cup to create an opening between the frame and rear cover. Next, insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Take out the rear cover and remove the board frame by undoing nine screws.

Next, disconnect both battery connectors from the board.

Next, take out the battery by loosening the adhesive.
First, loosen the adhesive on both sides and pull it by the tab. Be gentle and lift the battery. If the sticky is not relaxing, add some heat to soften the glue.

Next, take out the logic board.

First, disconnect both antennas, three main flex connectors and the touch id plug from the board.

Next, gently lift the board using a pry tool.

Take out the board, and next, release the front camera from the board.

Next, pull out the telephoto and ultrawide cameras by disconnecting both plugs.

Next, release the bracket to pull out the primary camera from the board.

Next, take out the rubber bracket.

Next, take out the button bracket.

Next, gently take out the power button with the touch id flex from the board.
Next, take out the volume button & flex.

Next, apply little heat and take out the earpiece module.

Next, take out the sensor flex and the bracket.

Next, move to the bottom and remove the cover by undoing seven screws.

Next, disconnect both main ribbon plugs, antenna and LCD plugs from the secondary charging port board.

Next, take out the charging port board, but first, take out the sim tray.

Next, take out the antenna with the board.

Next, apply little heat to take out the speaker.

Next, apply heat and take out the vibrator motor from the body.

Finally, pull out the main flex by moving the battery protective tape.

Stay tuned for the reassembly process and aftermath of the water clean-up process.

I hope you have enjoyed the teardown guide for repairs on the Redmi Note 11 Pro mobile phone. Let us know if you have any questions.