DIY Google Pixel 3a XL Camera Repair Guide

To start, we need to have the right tools to proceed with the repair, which You can find in the description.

At first, turn off the phone and remove the LCD screen removal from the front.

To remove the screen, it needs to heat gently around the screen edges until the pasted adhesive becomes soft. For this, we are using a heat gun.

Alternatively, you can use a heat pad or hairdryer around the screen edges until the pasted adhesive becomes soft.

Carefully work around on edges, and Once you feel the heating is enough, use a suction cup to lift the LCD Screen.

In between, Insert a Plastic Card pry tool and gently cut the adhesive around.

Lift the screen gradually and disconnect the connector plug by undoing two screws and removing the metal shield.

There is an adhesive strip on top of the connector. It is missing from this device.

If you have the sticky, peel it off and place, it while connecting the new lcd.

Next, take out the mid-frame plate by undoing fifteen screws.

And then, by using a plastic card pry tool or triangle picker, move around the phone to release the mid frame clips.

Next on the body, first, remove the sim tray.

And then disconnect the battery connector and followed by disconnecting six more connectors in the board.

Next, loosen the screw and take out the long bracket on the right edge.

To take out the Rear camera, you do not need to take out the logic board or loosen all connections.

Next, gently turn over the logic board and take out the broken front camera by disconnecting the plug.

Next, replace the broken front or rear camera with a new unit and place it on the board.

Next, place the logic board on the body and secure it by adding the screw.

Next, secure six plugs into the board, including the bracket.

And also, connect the battery plug to the logic board.

Next, place the midframe by adding fifteen screws.

Next, place the lcd screen on the body.

And then, connect the lcd plug and add the shield by inserting two screws.

And also the Tape which we don’t have but you may.

Before installing the LCD Screen, ensure it has enough glue on it; if not, use B7000 glue or a new double-sided LCD adhesive.

Finally, we are adding bonding clips to tighten the LCD screen with the body.

Leave it for some time and remove it.

On the other hand, you can use rubber bands and leave them for some time.

I hope you have enjoyed the replacement guide. Let us know if you have any questions.