DIY Samsung Galaxy A51 5g Charging Port Repair Guide

To start we need to have the right tools to proceed with the repair which you can find in the description first take out the sim tray and then the back cover removal to remove the back cover it needs to heat gently around the back coverages until the pasted adhesive becomes soft for this we are using a heating pad place the back core side on the heating pad and select the mobile phone heating option and leave it till it completes alternatively, you can use a heat gun or hair dryer once the heating has completed use a suction cup to create an opening between the frame and rear cover next insert a plastic carburetor tool or something similar to cut the adhesive around the back cover

Next, take out the back cover and take out the main board frame with the wireless coil by undoing screws undo nine screws and then using a pry tool lift the wireless coil by cutting the adhesive under it

next move to the bottom section and take out the second PCB cover by undoing eight screws

next, take out the cover and undo the screw securing the secondary board next disconnect the touch id camera main ribbon flex and LCD flex connectors

next disconnect the secondary board connection cable from the logic board

next, take out the secondary board including the charger port apply the heat and soften the glue under it be gentle in this process and take out the board using a pry tool

next replace the broken charging port with a new unit and place it on the board

next, secure the new secondary board including the charger port by adding the screw

next, connect the LCD plug main ribbon flex and touch the ID camera into the secondary board
next place the secondary cover by adding eight screws

next place the main board frame with the wireless coil to the body secure the frame by adding nine screws

before installing the main back cover make sure it has enough glue on it if not use b7000 glue or new double-sided back cover adhesive

Finally, we are adding binding clips to tighten the rear car with the body if not you can use some rubber bands and leave them for some time

hope you have enjoyed the replacement guide let us know if you have any questions