DIY Samsung Galaxy S10 Plus Front | Back Camera Repair Guide

To start, we need the right tools to proceed with the repair, which You can find in the description.

First, Take out the SIM tray and then the back cover removal.

To remove the back cover, it needs to heat gently around the rear cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad, select the mobile phone HEATING option, and leave it until complete. Alternatively, you can use a heat gun or hairdryer.

Once the heating has been completed, Use a suction cup to create an opening between the frame and the rear cover. Next, insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Take out the back cover, and Next, Take out the board frame with the wireless coil by undoing Nine screws.

And also, unplug the battery connector.

Next, move to the bottom and take out the bracket by undoing seven screws.

Next, On the top left, disconnect and take out the front camera from the board.

Next, disconnect the LCD connector and take out the headphone jack by unplugging the connector.

Next, Take out the logic board by undoing three screws. Be gentle and lift the board slowly.

Next, disconnect two connector plugs on the rear side of the logic board and apply slight pressure from the front side of the cameras to pull out the unit.

The camera unit comes as a 3 in 1 unit.

Next, place the new 3 1 rear camera unit and put it on the board by connecting two plugs.

Next, place the logic board in the body and secure the LCD connector.

Next, place the headphone jack and front camera in the logic board by connecting plugs. If your front camera has broken, place the new front camera in the body.

Next, secure the logic board by adding three screws.

Next, place the bottom bracket by adding seven screws.

Next, add the SIM tray and secure the battery connector.

Next, place the board frame with the wireless coil by adding nine screws.

Finally, Before installing the main back cover, ensure it has enough glue. If not, use B7000 glue or a new double-sided back cover adhesive.

I hope you have enjoyed the replacement guide.

Let us know if you have any questions