
If your Samsung Galaxy A53 5G is not charging properly, disconnects frequently, or the headphone jack has stopped working, the charging port board may be damaged. This component handles charging, data transfer, microphone, and headphone connectivity, so wear and tear or moisture damage can cause multiple issues.
In this guide, we’ll walk you through step-by-step instructions to replace the charging & headphone jack board on the Samsung Galaxy A53 5G safely and correctly.
This guide helps to fix issues related to headphone jack and microphone related problems.
You may need to replace the charging port board if:
Difficulty Level: 🟡 Moderate
⏱ Estimated Time: 30–45 minutes
Compatibility and Model Numbers
This repair guide based on Samsung Galaxy A53 5G Model.
Model Numbers | SM-A536B, SM-A536B/DS, SM-A536U, SM-A536U1, SM-A5360, SM-A536E, SM-A536E/DS, SM-A536V, SM-A536W, SM-A536N, SM-S536DL
How to Find Tools and Parts
Protect Your Samsung Galaxy A53 5G
Turn off the Samsung Galaxy A53 5G completely before starting the repair.
To remove the back cover, gently heat around the rear cover edges until the adhesive softens.
Q1: Will replacing the charging port fix microphone issues?
Yes, the microphone is part of the charging board. Replacing it often resolves mic problems.
Q2: Can I replace only the charging port connector?
No, the Galaxy A53 uses a full charging board assembly. The entire board must be replaced.
Q3: Do I need to replace the back cover adhesive?
If the original adhesive is weak, replacing it is strongly recommended.
Q4: Will this repair erase my data?
No, replacing the charging board does not affect stored data.
Q: Phone still not charging after replacement
A: Check the battery connector, main flex cable, and charging board screws.
Q: Headphones not detected
A: Ensure the headphone jack area is clean and the board is seated properly.
Q: No network signal after repair
A: Recheck antenna cable connections on the charging board.
Q: Phone not powering on
A: Confirm the battery connector is fully seated and no connectors are loose.
Related Repair Guides





