DIY Google Pixel 4XL Front Camera Repair Guide

To start, we need to have the right tools to proceed with the repair, which You can find in the description.

First, turn off the phone and follow the back cover removal.

For this, we are using a heating pad. Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes. Alternatively, you can use a heat gun or hairdryer.

Once the heating has completed, Use a suction cup to create an opening between the frame and rear cover. Next, insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

While removing the back cover, be gentle. The flash sensor plug connects with the back cover.

Next, take out the bracket by undoing four screws to undo the battery plug.

Next, take out the sensor bracket by undoing two screws. Please note one screw is missing on our device. And then disconnect the plug to release the back cover from the body.

Next, take out the left bracket on the board by undoing three screws.

Next, take out the right upper bracket by undoing three screws.

Next, take out the front camera and sensor module by disconnecting three connector plugs and undoing three screws.

Next, place the front camera module by securing three plugs and three screws.

Next, place the top-right bracket by adding three screws.

Next, place the shield by adding three screws.

Next, connect the back cover sensor flex to the board and place the bracket by adding two screws. Once again, our device has one screw, but yours should have two.

Next, secure the battery plug and place the bracket by adding four screws.

Next, Before installing the main back cover, make sure it has enough glue; if not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body. If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the replacement guide. Let us know if you have any questions.