DIY OPPO Find X3 Lite | Reno 5 5g Charging & Headphone Port Repair Guide

Before Starting, we need to have the right tools to proceed with the repair, which you can find in the description.

First, take out the back cover from the body. To remove the back cover, it needs to heat gently around the rear cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad, select the mobile phone heating option, and leave it till it completes.

Alternatively, you can use a heat gun or hair dryer. Once the heating has been completed, use a suction cup to create an opening between the frame and back cover.

Next, insert a plastic card pry tool or something similar to cut adhesive around the back cover.

Take out the back cover, and then take out the SIM tray.

Next, take out the mid-frame by undoing 18 screws.

Then, using your plastic upright tool, create an opening to separate the background frame. Be gentle and work around there. Just distinguish the plastic clips.

Next, disconnect the battery plug.

Next, undo the screw and take off the speaker module.

Next, disconnect the lcd cable, both main ribbon cables, two antenna heads, and the touch ID camera from the secondary charging port board.

Next, gently pull out the Touch ID camera from the board.

Next, take out the networking charging and headphone board from the body.

If the stick is strong, apply some heat to soften the adhesive under the board.

Next, place the new charging and headphone jackpot in the body.

Next, secure the lcd, two main ribbon connectors, and two antenna heads into the board.

Next, place and secure the touch ID camera.

Next, secure the speaker module by adding the screw.

Next, secure the battery connector.

Next, place and secure the mid-frame by adding 18 screws. Ensure the clips have been fastened before inserting the screws.

Next, before installing the main back cover, make sure it has enough glue. If not, use b7000 glue only double-sided back adhesive.

Finally, we are adding a binding crystal in the background with the body. if not, you can use server vans and leave them for some time

Hope you have enjoyed the replacement guide. Let us know if you have any questions.