DIY Samsung Galaxy A51 5g Front | Back Camera Repair Guide

To start, we need the right tools to proceed with the repair, which You can find in the description.

First, Take out the SIM tray and then the back cover removal.

To remove the back cover, it needs to heat gently around the rear cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad.

Place the back cover side on the heating pad Select the mobile phone HEATING option and leave it till it completes.

Alternatively, you can use a heat gun or hairdryer.

Once the heating has been completed, Use a suction cup to create an opening between the frame and the rear cover.

Next, insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Next, take out the back cover and take out the Main Board frame with the wireless coil by undoing the screws.

First, Undo nine screws and then, using a pry tool, lift the wireless coil by cutting the adhesive under it.

Next, Disconnect the battery plug.

Next, undo the screw in the logic board and disconnect both main ribbon connectors.

Next, disconnect and take out the front camera from the body.

Next, gently take out the logic board from the body.

Next, take out the 3 1 camera module by disconnecting three plugs from the rear side of the logic board.

Next, disconnect and Take out the macro camera from the front side.

Next, Replace the required Broken camera unit with a new one and place it on the board.

First, place the front camera and then place the rear camera on the board.

Next, place the logic board in the body and secure the screw.

Next, secure the battery connector and both Main connector plugs into the logic board.

Next, add the SIM card tray and place the mainboard frame with the wireless coil to the body.

Secure the frame by adding nine screws to the mainboard frame.

Before installing the main back cover, make sure it has enough glue on it; if not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body.

If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the replacement guide.

Let us know if you have any questions