DIY Huawei P20 lite | Nova 3e Charging Port & Headphone Jack Repair Guide

Before Starting, we need to have the right tools to proceed with the repair, which you can find in the description.

First, turn on the phone and remove the back cover. Here, we are using a heating pad to remove the back cover. Place the back cover side on the heating pad, select the mobile phone heating option, and leave it till it completes.

Alternatively, you can use a heat gun or hair dryer. Once you feel the heating is enough, use a suction cup with the back cover. In between, insert a plastic card pry tool and gently cut the adhesive around.

While taking out the back cover, be gentle. The fingerling plug is attached to the back cover.

Next, remove the fingerprint bracket by undoing two screws.

Next, disconnect the battery plug and disconnect the fingerprint plug.

Now, the back cover unit can be from the body.

Next, move to the bottom and take off the speaker cover by undoing 7 screws.

Next, remove the network in the charging port board by disconnecting the antenna head and the main different flex.

Next, place the new charging port board on the body.

Next, secure the antenna head and main flex to the board.

Next, secure the speaker cover by adding seven screws.

Next, connect the fingerprint and battery plugs to the board.

Next, place the shield by adding two screws.

Next, before installing the main back cover, make sure it has enough glue. If not, use b7000 glue on your double-sided back adhesive.

Finally, we added the binding clip to tighten the rear cover with the body. If not, you can use some rubber bands and leave them for some time.

Hope you have enjoyed the replacement guide. Let us know if you have any questions.