DIY Motorola Moto G Power 2021 XT2117 Camera Lens Glass & Flash Sensor Repair Guide

Before Starting, we need the right tools to proceed with the repair, which You can find in the description.

First, Take out the back cover from the body. To remove the back cover, it needs to heat gently around the rear cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad and Select the mobile phone HEATING option and leave it till it completes.

Alternatively, you can use a heat gun or hairdryer.

Next, create an opening using a suction cup and then insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Next, gently pull out the back cover from the body.

Next, remove the back cover and undo eleven screws to take out the logic board frame with the lens.

Next, take out the broken lens from the frame.

Apply heat from the front side, and then push from the rear side to remove the lens.

If your lens has many cracks, gently take out pieces front the front side.

Next, clean the surface and place the new lens glass with the adhesive.

Next, if needed, take out the flasher lens from the rear side of the lens socket.

Gently, using a tweezer, pull out the not working flasher sensor with the frame.

Next, disjoin the frame and sensor board.

Next, place the new flash sensor board with the frame.

Next, secure the flash sensor in the lens socket.

Also, You can replace the broken glass lens nwith the frame.

Next, Apply heat to the lens area from the front side and gently push the lens frame.

If you are using the glass lens with the frame, pull out the flash sensor from the old unit and secure the flash sensor in the new lens frame.

Next, secure the lens frame with adhesive.

Next, secure the board frame with the lens by adding eleven screws.

Next, Before installing the main back cover, ensure it has enough glue.

If not, use B7000 glue or a new double-sided back cover adhesive.

Finally, we are adding bonding clips to tighten the rear cover with the body.

If not, you can use some rubber bands and
Leave them for some time.

I hope you have enjoyed the replacement guide. Let us know if you have any questions.