DIY OPPO Find X2 Lite 5G | Reno 3 5g Charging Port Flex Repair Guide

Before Starting, we need the right tools to proceed with the repair, which you can find in the description.

First, take out the back cover from the body. To remove the back cover, it needs to heat gently around the back cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad, select the mobile phone heating option, and leave it till it completes.

Alternatively, you can use a heat gun or hair dryer.

Once the heating completes, use a suction cup to create an opening between the frame and the back cover.

Next, insert a plastic card pry tool or something similar to cut the adhesive around the back cover.

Take out the back cover and then undo 11 screws to take out the board cover.

Next, disconnect the battery plug.

Next, release the adhesive on the right-hand side, then pull the battery from the tab.

Take out the battery and then remove the secondary speaker board cover by undoing 11 screws.

Next, move the battery protective tape to the left-hand side.

Next, release the adhesive strip on the edge.

Next, disconnect the charging and main flex connectors from the logic board.

Next, disconnect the other half of the main flex. And then the charging port connector from the secondary board.

Next, pull out the main flex from the body.

Next, release and pull out the networking charging port cable from the body.

Next, place a new charging port cable on the body.

Next, place and secure the main flex cable from both ends.

Next, secure the battery protector tape and adhesive strip back.

Next, secure the speaker cover by adding eight screws.

Next, place the battery and secure the tape.

Next, connect the battery plug.

Next, secure the board frame by adding 11 screws.

Next, before installing the main back cover, ensure it has enough glue. If not, use b7000 glue on your double-sided back adhesive.

Finally, we are adding binding clips to tighten the rear cover with the body. If not, you can use some rubber bands and Leave them for some time.

I hope you have enjoyed the replacement guide. Let us know if you have any questions.