DIY Xiaomi Redmi Note 10 Teardown Repair Guide

Before Starting, we need to have the right tools to proceed with the teardown, which you can find in the description.

First, turn off the phone, take off the sim tray, and then follow with the back cover removal.

To remove the back cover, it needs to heat gently around the back cover edges until the pasted adhesive becomes soft.

For this, we are using a heating pad. Place the back cover side on the heating pad, select the mobile font heating option, and leave it till it is complete.

Alternatively, you can use a heat gun or hair dryer. Once the heating has been completed, use a suction cup to create an opening between the frame and the rear cover.

Next, insert a plastic car pry tool or something similar to cut the adhesive around the back cover.

Take out the rear curve and take out the camera lens frame by undoing the screws. Undo four screws and lift the camera lens cover using a pry tool.

Next, take out the mid-frame by undoing 13 screws on the top and bottom sections.

And then using a plastic card pry tool. Create an opening to separate the back cover frame. Be gentle and walk around on the edges to disable plastic clips.

While you are taking out the frame, be gentle. The fingerprint flex is attached to the mid-frame, and disconnecting the flex cable releases the mid-frame from the body.

Next, from the right-hand side, disconnect the battery plug. And then take out 4 rear cameras on the top left in the logic port.

Then disconnect and take out the front camera on the top center.

Next, disconnect the lcd connector plug and both ends on the main ribbon cable, and then pull out the logic board by disconnecting the antenna head.

Next, apply the heat to take out the speaker and sensor flex module, be gentle, and slowly pull out the parts.

Next, move to the bottom part and lift the loudspeaker buzzer, and then lift the secondary board, including the charger port and headphone jack, by disconnecting the antenna head.

Next, disconnect the lcd plug and then pull out the vibrator motor by applying a little heat.

Next, take out the battery by loosening the adhesive first, loosen the adhesive on both sides, and then pull it by the tab. Be gentle and lift the battery.

Finally take out the lcd extension cable from the body

Hope you have enjoyed the replacement guide. Let us know if you have any questions.